Follow on Facebook

ANSYS FLUENT – Scale Mesh

In this tutorial, you will learn how to scale the mesh of any geometry and change the units in ANSYS FLUENT directly, this option is enabled in all versions from Workbench.

Always check your mesh and the scale because one reason of Why no reach the convergence is for the scale of mesh, that is an important point to review before to start a simulation.

 

Readers Comments (7)

  1. PRASANNA SREEPADA June 24, 2018 @ 12:07 am

    Sir,

    I am trying to simulate the water level fluctuations in a tank that will come to rest after sometime.. Could you please suggest any tutorial

    Reply
  2. i am trying to simulate air conditioning in a room from autodesk inventor but is always divergence, do you know why?

    Reply
    • Hi friend, Maybe the mesh or one boundary conditions are wrong, you should check again your project. Regards

      Reply
  3. Hi Admin,
    Please I’m new to Ansys fluent. I’m trying to simulate sprays from flicking wet brush bristles. Can you help me with a tutorial video.
    Thanks

    Reply
  4. Hi admin,
    I’m new to Ansys fluent. I want to simulate the spray from flicking wet brush bristles as in splatter painting. Any tutorial video will be appreciated.
    Thanks

    Reply

Leave a comment

Your email address will not be published.


*